
The proper positioning
The installation site depends on the type of curtain. If the curtain is opaque, but lightly translucent, then you can aim HOMESHADOWS directly at the curtain. Should there be no curtain, or it is transparent, then direct HOMESHADOWS at the walls that are visible from the outside.
In principle, it is about making visible moving shadows to the outside and setting HOMESHADOWS in such a way that the device cannot be seen from the outside. This is best done with opaque, but translucent curtains or blinds.
In the case of opaque, but lightly translucent curtains or blinds, aim HOMESHADOWS directly at these objects.
light transparent
tripartite
at terrace door
made of fabric
with slats

For windows and doors without curtains or with transparent curtains, aim HOMESHADOWS with walls so that light and shadow can be seen from outside.
first floor

Setup instruction
3 Steps to security



» AUTO:
HOMESHADOWS is automatically switched on in darkness (< 2 lux = very dark), and it is automatically switched off again after 6-7 hours. The blue status LEDs signal readiness.
» ON:
HOMESHADOWS is constantly on.
In this mode, you can set up other activation and switch-off times using an external time switch.
» OFF:
HOMESHADOWS is switched off.


Setup examples for HOMESHADOWS
In „AUTO” mode please pay attention to the setup examples so that HOMESHADOWS can detect day and night. In „ON” mode, however, any placement is possible.













